How to integrate SmartWave shades into your SmartThings – SmartWave Shades

This guide covers the following shade types: Roller Shades, Zebra Shades, Roman Shades, Woven Wood Shades, Shangri-La Shades, Outdoor Shades, and Dual Shades.

Note:
1. Please avoid setting the device while charging to ensure accurate indicator light display.
2. You need to choose a compatible Thread border router for the app you are using and ensure that this Thread border router is connected to the app and functioning properly.
3. Please ensure the motor is in pairing mode before scanning the code. If it is not, close the app, switch the motor to pairing mode, and then reopen the app to scan the code.

Watch the video below to learn how to integrate SmartWave shades into your SmartThings.

1. Enter pairing mode

Step 1 Use the remote control to move the shades to approximately the middle position between the upper and lower limit travels.

Step 2 Press both the 'UP' and 'DOWN' buttons on the remote control simultaneously for 2 seconds. The shades will tremble up and down once, and the indicator light will turn orange and flash continuously.

Step 3 Pressing the 'UP' and 'STOP' buttons on the remote control simultaneously causes the shades to tremble up and down once, and the indicator light will turn green and flash continuously for about two minutes.